ON - Enables the output from the plugin.You can assign 3 extra pairs of outputs by clicking Out 2 to 4 to expose additional pairs of Left and Right CV controls. When the Voltage Controller receives a note from the Piano roll, it will output a voltage on the Audio Interface output.īy default, the Main Outputs are used. Naturally, any Audio outputs, re-purposed for CV control will be connected to your CV hardware and no longer available for audio duties. Your audio interface must be designed to operate in DC coupled mode. Most audio interfaces can't output fixed DC (Direct Current) voltages and are designed to output Alternating Current (AC), signals. Rather, the signal from Fruity Voltage Controller is sent to an audio interface connected to analog controlled audio devices. NOTE: This plugin is NOT designed to be used with an Audio Interface connected to speakers. Normally you would use an instance of Voltage Controller for each voice module in your setup. The Left and Right channels of a DC coupled Audio Interface can be used to separately control two CV modules or different parameters of the same module, such as pitch and gate (as mentioned above). The CV typically controls pitch and the gate signal controls note on and off. CV is an analog method of controlling synthesizers, drum machines and other similar equipment. Fruity Voltage Controller controls up to 8 channels of Control Voltage (CV) hardware.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |